2020. 1. 24. 03:23ㆍ카테고리 없음
.230V SMOKE & HEAT ALARMS ALKALINE BATTERY BACK-UP Ei141RC - Ionisation Ei144RC - Heat Ei146RC - Optical RECHARGEABLE LITHIUM CELL BACK-UP Ei161RC - Ionisation Ei164RC - Heat Ei166RC - Optical USER INSTRUCTIONS 1. REGULAR CHECKS Look for: Constant green light Red light flash every 40 sec.www.acornfiresecurity.com 2. ALARM REMOVAL LOCATE REMOVAL SLOT LOCATE THE ARROW ON THE FRONT FACE OF THE ALARM. THE SLOT IS LOCATED DIRECTLY ABOVE THE ARROW. INSERT SCREWDRIVER INSERT A FLAT-BLADED SCREWDRIVER HORIZONTALLY APPROX.
Ei 131 Smoke Alarm Manual Free
- Aico EI146RC Smoke Alarm Optical Aico's highly reliable, cost-effective alarm solution with Alkaline battery back-up. More responsive to smouldering fires (Sofas, TVs) Proven optical sensor with insect screen to reduce false alarms Third Party Accredited by BSI BS EN KM 552831 Fit in: Hallway, Landing, Living Room.
- You have selected Aico EI140 Mains Voltage Smoke & Heat Alarms. Browse through the range of products in the table below. Designed for applications where the budget is a key consideration and where maintenance is in the hands of the owner occupier or there is no requirement for lithium power cell back-up.
1cm INTO THE CENTRE OF THE REMOVAL SLOT SLIDE ALARM OFF BASE WITH THE SCREWDRIVER STILL INSERTED, PUSH THE LOWER HALF OF THE ALARM AWAY FROM THE SCREWDRIVER, IN THE.www.acornfiresecurity.com 3. IMPORTANT INFORMATION Do not paint your alarm. Do not allow paint, water or dust to contaminate your alarm.
Installation / User Guide Smoke Alarms Regulations Specification. Product Code. Price (ex VAT). Battery Smoke Detector with Hush Feature.
Your alarm is a mains 230V AC electrical appliance. Do not open or insert anything into the alarm. Regularly check that the green mains indicator light on the cover is lit.www.acornfiresecurity.com 4.
CHANGING THE BATTERY (Models Ei141RC / 144RC / 146RC only) 1. Switch off mains power to alarm (green light on cover should go out). Remove unit as shown in “ALARM REMOVAL” section on page 2. Locate battery slot in base of alarm as shown below. 4.www.acornfiresecurity.com (ii) Press the test button for up to 10 seconds to ensure the sensor chamber, electronics and sounder are working. A red light on the cover, will flash while horn is sounding. The alarm will stop when the button is released.www.acornfiresecurity.com (Long term storage (over 1 year) can damage the batteries such that they will not recharge when the units are re-connected to the mains supply).
5.1 If the unit is beeping The Alarm automatically monitors the battery every 40 seconds.www.acornfiresecurity.com A unit will operate from the mains alone, even with a fully depleted or a defective battery (and give beeps every minute), though it may not give sufficient warning of fire if the mains supply is disconnected for any reason. If there are any problems get a qualified electrician to inspect the house wiring and connections to the alarms.www.acornfiresecurity.com 7. NUISANCE/FALSE ALARMS When sure that it is just a nuisance/false alarm, simply press the test/silence button briefly on the Alarm to silence the unit for 10 minutes. If, when the alarm goes off, there is no sign of smoke, heat or noise to indicate that there is a fire, you should get your family into a safe place, before you start investigating.www.acornfiresecurity.com 8. IMPORTANT SAFEGUARDS When using household protective devices, basic safety precautions should always be followed, including those listed below:. Please read all instructions. Rehearse emergency escape plans so everyone at home knows what to do in case the alarm sounds.
Further information can be obtained from the Home Office Publication or from your local fire prevention officer.www.acornfiresecurity.com 3. Get out as fast as you can. Do not stop for packing. Have a prearranged meeting place outside for all family members. Check everybody is there.
Call Fire Brigade immediately on a mobile phone or from a neighbour’s house. Make sure to call the Brigade for fires no matter how small - fires.This guarantee excludes incidental and consequential damage.
If this Alarm should become defective within the guarantee period, it must be returned to Ei Electronics, with proof of purchase, carefully packaged, with the problem clearly stated. (see “Getting Your Alarm Serviced”) We shall at our discretion repair or replace the faulty unit.www.acornfiresecurity.com 13. TROUBLESHOOTING 1. FREQUENT NUISANCE/FALSE ALARMS OCCUR: (1) Close kitchen / bathroom door when in use. (2) Ensure that the alarm is sited at least 6m away from sources of fumes. (3) Contamination from insects, paint or paint fumes may have occurred.www.acornfiresecurity.com (2) If an Optical unit (Ei146RC/166RC) beeps without the red light flashing at the same time, the chamber is defective. Clean the chamber.
The Ei141RC Ionisation Smoke Alarm is a mains powered alarm with a 9V Alkaline battery back-up and contains a proven long life Ionisation smoke chamber.Different alarms sensors work best at detecting different types of fire and so should be sited in appropriate rooms throughout a property. Ionisation alarms are best at detecting fast flaming fires which are commonly caused by clothing and paper.Fit in: BedroomThe alarm is supplied with an to make it as quick and simple to install. As with the rest of the 140RC Series alarm the Ei141RC Ionisation alarm can be interconnected with other alarms and accessories through hard wire connection or, for less mess and disruption, by wireless interconnection.As this alarm contains a 9V Alkaline battery back up, this battery will need changing over the course of it’s ten year life.
Click here for our. The Ei141RC Ionisation Smoke Alarm is a mains powered alarm with a 9V Alkaline battery back-up and contains a proven long life Ionisation smoke chamber.Different alarms sensors work best at detecting different types of fire and so should be sited in appropriate rooms throughout a property. Ionisation alarms are best at detecting fast flaming fires which are commonly caused by clothing and paper.Fit in: BedroomThe alarm is supplied with an to make it as quick and simple to install. As with the rest of the 140RC Series alarm the Ei141RC Ionisation alarm can be interconnected with other alarms and accessories through hard wire connection or, for less mess and disruption, by wireless interconnection.As this alarm contains a 9V Alkaline battery back up, this battery will need changing over the course of it’s ten year life. Click here for our.